![]() Check the documentation that came with the fixture, for proper wiring instructions. This answer assumes the black wire controls the fan, while the blue controls the light kit on the fan. This way the remote module will control the fan (when the switch is in the ON position), and the other switch will control the light. You'll end up with something like this.Īlternatively, you could wire it like this. The other switch will turn the fan on and off. ![]() This includes a ceiling fan motor, a switch, a wall switch and other hardware. Now when one switch is on, the remote will control the light. A Harbor Breeze ceiling fan wiring diagram includes all the components required for installation. Cap off the black and white wire from the output side of the remote receiver module.Connect the red wire from the ceiling to the black wire in the fan.The green wire is a ground wire and should be connected to a grounding point such as a metal box. Identify the wires coming from your fan, control receiver, ceiling bracket, and ceiling fan rated electrical box. Using a step stool or ladder if needed, remove the canopy screws from the fan’s canopy using a Philips screwdriver. The black wire is the hot wire and supplies power to the fan. Turn the power to the electrical outlet box off. All of these wires are used to connect the fan to the wall switch. The white wire is the neutral wire, the black wire will power the ceiling. Connect the blue wire from the output side of the remote receiver module to the blue wire in the fan. The Harbor Breeze ceiling fan wiring diagram typically includes a black, green, blue, white, red, and yellow wire. After you open the ceiling fan canopy you will find there are three coloured wires.Connect the black wire from the ceiling to the black wire on the input side of the remote receiver module.Connect the white wire from the ceiling to the white wire on the input side of the remote receiver module and the white wire in the fan.Connect all the bare or green grounding conductors together.Start by turning off the power at the breaker, and verifying it's off with a non-contact voltage tester.I think I'll have to return the fan, but please let me know if anyone has any other ideas (and, no, the breaker hasn't tripped, and there are fresh batteries in the remote, and the dip switches on the receiver and remote are set to same frequency). The instructions to the fan offer no useful guidance on this issue. If your Ceiling Fan is not responding to the remote control then this could be due to a loose wire within the receiver unit, a burnt-out receiver unit, or your remote control needing to be reset or resynced with the fan. I just got done doing that, but still the remote won't work! The wiring looks good and I have run out of ideas. I then decided that I would remove the switch from the equation and direct wire the fan so that the remote controlled everything, and the switch would no longer interrupt the power. Yet again, I checked the connections, but nothing seemed to make it work this time. One day later, my wife turned the switch off YET AGAIN, and guess what? The remote stopped working again no fan, no light, even after the switch was turned back on. I checked the wiring and "magically" (and I still don't understand why because all the connections were good) the remote started working again. ![]() However, after my wife turned off the light switch to the fan, the remote stopped working, even after we turned the switch back on. We installed last week and everything worked fine (remote worked fine all functions). ![]() I think I'm having similar problem with my new fan (Hampton Bay). ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |